Thread
Design guides

3D printing design guide

Rules a Manufex engineer applies before a 3d printing estimate leaves the thread.

Walls 1 mm and up
SLS and MJF hold 1.0 mm; SLA holds 0.8 mm. Thinner walls warp or fail to print.
Escape holes for hollows
Two holes of 3 mm or more let unsintered powder out.
Say which surface matters
Orientation sets the finish. Tell us the critical face and we orient for it.
Avoid large flat slabs
Flat sections over 100 mm curl in SLS and warp in FDM. Add ribs or split the part.
Tolerance to the process
±0.3 mm or ±0.3% in nylon. Ream or machine anything tighter.
Fillets on load paths
Printed parts crack at sharp internal corners under load.
Threads: inserts, not printed
Heat set or printed clearance holes for inserts outlast printed threads.
Supports cost
In SLA and DMLS, overhangs past 45° need supports and leave marks.

Have the file? Send it.

We apply these rules to your part before anything is quoted.

Start sourcing