Thread
Design guides

CNC machining design guide

Rules a Manufex engineer applies before a cnc machining estimate leaves the thread.

Radius every internal corner
A corner radius of one third the pocket depth lets a standard end mill cut it in one pass.
Keep walls thick
Below 0.8 mm in metal walls chatter and warp; the shop slows down and the price goes up.
Limit hole depth
Holes deeper than 6× diameter need special drills. Keep threads to 3× diameter.
Avoid deep narrow pockets
Depth over 4× width means long tools, slow feeds and taper on the walls.
Use standard sizes
Standard drills, taps and reamers are in every shop. Odd sizes add a tool order.
Tolerance only what matters
A ±0.025 mm callout on every dimension doubles inspection time. Put it where the fit is.
Mind the setups
Features reachable from two faces cost less than features that need five.
Flat is not free
Thin plates relax after machining. Call out flatness only on the mating face.

Have the file? Send it.

We apply these rules to your part before anything is quoted.

Start sourcing