Thread
Design guides

Injection molding design guide

Rules a Manufex engineer applies before a injection molding estimate leaves the thread.

Uniform walls
1.5 to 3 mm for most resins. Thick sections sink and warp.
Draft on every vertical face
1° per side minimum, 3° where the face is textured.
Ribs at 60% of the wall
Thicker ribs show sink marks on the outside face.
Radius the corners
Inside radius at least half the wall thickness. Sharp corners concentrate stress and trap melt.
Mind the undercuts
Each undercut needs a slide or a lifter. Design them out where you can.
Bosses with gussets
Standalone bosses crack. Tie them to a wall or add gussets.
Say the gate location
If the witness mark matters, tell us which face can carry it.
Match the resin to the finish
High gloss on glass-filled nylon does not exist. Pick the finish with the material.

Have the file? Send it.

We apply these rules to your part before anything is quoted.

Start sourcing