Thread
Design guides

Metal forming and die casting design guide

Rules a Manufex engineer applies before a metal forming and die casting estimate leaves the thread.

Draft on cast walls
1 to 2° on die cast walls, more on deep cores.
Blend the sections
Abrupt wall changes cause porosity and shrink. Blend with radii.
Put datums on the drawing
A casting with no machined datums cannot be held for secondary ops.
Stamping: grain direction
Bends parallel to grain crack. Call out grain where it matters.
Forging: parting line
Say where the flash can be. It drives the die design.
Holes after casting
Small holes are drilled, not cast. Design for the drill.
Wall minimums
2 mm aluminum die cast, 1 mm zinc. Thinner walls do not fill.
Quote the tool separately
Tooling is a line item. Ask who owns it and where it lives.

Have the file? Send it.

We apply these rules to your part before anything is quoted.

Start sourcing