Thread
Design guides

Sheet metal design guide

Rules a Manufex engineer applies before a sheet metal estimate leaves the thread.

One thickness per part
Sheet metal is one gauge. Model it that way.
Bend radius at least 1T
Inside radius equal to the material thickness avoids cracking on the outside of the bend.
Keep holes away from bends
Hole edge to bend at 2.5T plus the bend radius, or the hole distorts.
Add bend reliefs
A relief at the end of each bend stops tearing at the corner.
Flange length 4T minimum
Short flanges cannot be held on the press brake.
Specify PEM hardware by number
Part number and side of insertion. Description alone gets the wrong one.
Weld only where needed
Tabs and slots locate parts; welds add distortion and cost.
Finish before assembly
Say whether the coat goes on before or after hardware. It changes the sequence.

Have the file? Send it.

We apply these rules to your part before anything is quoted.

Start sourcing